Owner's Manual

489
- LSP Metric into Summary (only available if Shortcuts is selected)—Advertise LSP metric into
summary LSAs
-
No Topology —Disable dissemination of TE link-state topology information
The
Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.
ISIS
This tab lets you control ISIS settings for the selected device.
Figure 13-52. Routing Protocols -> Setup: ISIS
This screen has the following fields:
General Settings
LSP Lifetime —Lifetime of LSPs (350 - 65535 seconds). How long an LSP originating from the
router should persist in the network. The router sends LSPs often enough so that the LSP lifetime
never expires. Default: 1200 seconds
Disable ISIS —Do not enable this configuration
-
Overload Timeout —Time after which overload bit is reset (60 - 1800 seconds)
-
Overload —(checkbox) Set the overload bit (no transit traffic).