Owner's Manual

462
}
}
}
}
Updating IP Addresses on Routing Engines
The following property helps those who manage the router with a loopback address or port other
than the management port and (for some reason) need to configure the IP on the routing engines
(REs).
com.dorado.devicedriver.juniper.updatemanagement=true
If set to true (the default), this always updates the management interfaces after a failover between
REs. In some cases, you may not want to update these -- if you use loopback interfaces for routing
purposes, for example.
Configure the IP on the REs when there are dual routing engines in the Groups section of the
config with two groups with special names, re0 and re1. Which ever RE is the master is the config
that is in play, at the time of the switchover the other is used.
Configure -> Redundancy
With this device driver, you can configure or view the master or backup RE.