Owner's Manual

456
Figure 13-32. Class of Service -> Interfaces -> Rewrite Rules Tab
Here, you can configure the following with pick lists, or checkboxes:
-
DSCP —Differentiated Services code point (DSCP) rewrite rule.
-
EXP —EXP rewrite rule.
-
Protocol —Specify protocol matching criteria.
mpls-any—Apply to MPLS packets, write MPLS header only.
mpls-inet-both—Apply to IPv4 MPLS packets, write MPLS and IPv4 header.
mpls-inet-both-non-vpn—Apply to IPv4 MPLS packets, write MPLS and IPv4 header for
only non VPN traffic.
- IEEE-802.1 —IEEE-802.1 rewrite rule.
-
Inet-Precedence —IPv4 precedence rewrite rule.
-
DSCP Ipv6 —Differentiated Services code point rewrite rule IPv6 (Junos 6.3 & above).
-
Exp-Swap-Push-Push —Check to copy incoming EXP into all swap-push-push labels.
-
Exp-Push-Push-Push —Check to enable top-label EXP rewrite rule for push-push-push
operation.
This panel contains drop-down options defined and created in Class of Service -> Rewrite Rules on
page 449
The
Configure button at the bottom of the screen sends the selected configuration to the device.
The
Refresh button queries the device and retrieves the active COS configuration for this unit.
Class of Service -> Fragmentation Map
This screen configures fragmentation maps for the selected device.