Owner's Manual

447
you, in effect, select Discrete. There, specify the fill-level and drop-probability percentage values. If
you select
Interpolate , you can configure each drop probability up to 64 Fill-level/ Drop-probability
pairs, or a profile represented as a series of line segments
Click
Add to create a new drop profile, or select one from those listed and select Edit. Click Delete
to remove selected profile. Click
Export to save a description of the listed items to a file. Click
Apply to accept your edits, or Cancel to abandon them. The Drop Profile Properties panel has the
following fields:
-
Name —Up to 64 characters describing the Drop-Profile.
-
Interpolate —(check box) When the drop-profile is interpolated, for Fill-Levels and Drop-
Probabilities
, you can specify 1-64 values ranging from 0-100. Multiple values are added/
removed by using the
Add/Delete buttons for the Fill-Level and Drop-Probabilities lists.
Enter the following two fields below the table of pairs at the bottom of the screen. Click
Add to
enter your values, and
Update to edit an existing pair. Delete removes the selected pair from the
list. Note also that you can use the up/down arrows to the right of this table to re-order these pairs.
-
Fill-Level —If the drop-profile is not interpolated then this value represents queue full
percentage. For interpolated profiles, it represents the data points for queue full percentage.
-
Drop-Probability —If the drop-profile is not interpolated then this value represents packet drop
probability. For interpolated profiles it represents the data points for packet drop probability.
The
Configure button executes the desired configuration on the selected equipment.Click the
Refresh button to re-query for these items.
Class of Service -> Schedulers
This manages the scheduler for COS to let you define the priority, bandwidth, delay buffer size,
rate control status, and RED drop profiles to be applied to a particular forwarding class for packet
transmission.