Owner's Manual

442
Figure 13-20. Aggregated Devices -> AE Interfaces
You configure an aggregated Ethernet virtual link by specifying the link number as a physical device
and then associating a set of ports that have the same speed and are in full-duplex mode. The
physical interfaces can be either Fast Ethernet, Gigabit Ethernet, Gigabit Ethernet IQ, or 10-
Gigabit Ethernet devices. Generally, you cannot use a combination of these interfaces within the
same aggregated link; however, you can combine Gigabit Ethernet and Gigabit Ethernet IQ
interfaces in a single aggregated Ethernet bundle.
On the aggregated bundle, no IQ-specific capabilities such as MAC accounting, VLAN rewrites,
and VLAN queuing are available.
Click
Add (or select an existing aggregate ethernet interface and click Edit ) to open the editor. You
can also click
Delete to remove a selected interface at the top of this screen. Click Export to save a
description of the listed items to a file. Once you have edited an interface, click
Apply to accept
your edits for the list, or click
Cancel to abandon them. The editor has the following fields:
Aggregate Ethernet Interface Properties
- AE Interface Name —An identifier for the interface.