Owner's Manual

422
- Source Port —Select the source from the pick list (see Destination Port for available options.
-
ICMP Code —Select the ICMP Code from the pick list. Options include none, communication-
prohibited-by-filtering, destination-host-prohibited, destination-host-unknown, destination-
network-prohibited, destination-network-unknown, fragmentation-needed, host-precedence-
violation, host-unreachable, host-unreachable-for-tos, ip-header-bad, network-unreachable,
port-unreachable, precedence-cutoff-in-effect, protocol-unreachable, redirect-for-host,
redirect-for-network, redirect-for-tos-and-host, redirect-for-tos-and-network, required-option-
missing, source-host-isolated, source-route-failed, ttl-eq-zero-during-reassembly, ttl-eq-zero-
during-transit.
-
ICMP Type —Select the ICMP Type from the pick list. Options include none, echo-reply, echo-
request, info-reply, info-request, mask-reply, mask-request, parameter-problem, redirect,
router-advertisement, router-solicit, source-quench, time-exceeded, timestamp, timestamp-
reply, unreachable.
- SNMP Command —Select the SNMP command from the pick list. Options include none, get,
get-next, get-response, set, trap.
- UUID —Match universal unique identifier for DCE RPC objects.
-
RPC Number —Match range of RPC program numbers.
-
TTL Threshold —Traceroute TTL threshold (0 - 255).
-
Inactivity Timeout —Application-specific inactivity timeout (4 - 86400 seconds).
Application Sets
An application protocol defines application parameters using information from network Layer 3
and above.