Owner's Manual

415
Making a Link
This describes the process of making and verifying an ISIS link between two J-series devices:
1 After you discover two J-series devices (we’ll call them “A” and “B”) right-click an interface (fe
0/0/0) and select
Open.
2 In Configure -> Units, select the iso tab, click Enable, and enter
49.0001.0245.0245.0245.00 as the ISO Network Address.
An ISO address—for example,
49.0001.0118.0118.0118.00— is 16 bytes. Reading from
right-to-left, the last
00 is the NSAP selector and is always 00 . The 0118.0118.0118 is the
system ID, which should be unique on your network. The
49.0001 is the Area address.
Finally,
49 indicates that the ISO address is private.
3 Click Apply and Configure
4 Edit the entire managed resource where you just configured the interface above.
5 Click to open Discrete Config -> Configure -> Protocols -> Setup, and select the ISIS tab.