Owner's Manual

387
Figure 13-125. VLAN ->Protocol Group
Yo u c an Add, Edit or Remove Protocol Group settings for the selected device in this screen. Click
Remove to delete a selected, listed item. When you click Add (or select an existing interface listed
in the
Protocol Group Settings portion of the screen and click Edit ) the Protocol Group Editor
opens (the lower portion of the screen) with the following fields:
-
Frame Type —The packet type. Possible field values are Ethernet, RFC1042 , and LLC Other .
Protocol
- Ethernet-Based —The Ethernet protocol group type. The possible field values are IP, IPX and
IPV6.
-
Specify Value (Hex) —A user-defined value to identify the protocol group.The value has to be
even number of hex digits(0-9,a-f)
-
Group ID — The VLAN Group ID number.
Click
Apply to accept the edits you have configured and add it to the list. Cancel abandons your
edits.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.