Owner's Manual

386
Admin Advertisement — When enabled, check Max Capability, 10 Full, 100 Full or 1000 Full.
Speed
—The speed at which the LAG is operating.
-
Back Pressure — Enable/Disable Back Pressure mode on the LAG. Back Pressure mode is effective
on the ports operating in Half Duplex in the LAG.
-
Flow Control — Enable/Disable/Auto Negotiation . Flow Control mode is effective on the ports
operating in Full Duplex in the LAG.
Click
Apply to accept the edits you have configured and add it to the list. Cancel abandons your
edits.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.
VLAN -> Protocol Group
The Protocol Group page provides parameters for grouping protocols for filtering, configuring
frame types to specific protocol groups. Protocol filtering prevents certain protocol traffic from
being forwarded out switch ports. This filters broadcast and unicast traffic based on the
membership of ports in different protocol groups. This filtering is in addition to the filtering
provided by port-VLAN membership.
Protocol filtering identifies ports based on protocol. A port can be a member of one or more of the
protocol groups. The device forwards flood traffic for each protocol group out a port only if that
port belongs to the appropriate protocol group. Layer 2 protocols, like Spanning Tree Protocol
(STP), are not affected by protocol filtering.