Owner's Manual

385
LAG Settings
The Switch -> LAG Settings screen contains fields for configuring parameters for configured
LAGs. The device supports up to eight ports per LAG, and eight LAGs per system.
NOTE:
If you modify port configuration while the port is a LAG member, the configuration change is only
effective after the port is removed from the LAG.
Figure 13-124. LAG Settings
Yo u c a n Edit LAG settings for the selected device in this screen. Click Remove to delete a selected,
listed item. When you select an existing interface listed in the
LAG Settings portion of the screen
and click
Edit the LAG Editor opens (the lower portion of the screen) with the following fields:
-
LAG —The LAG number.
-
Description (0-64 Characters)—Provides a user-defined description of the configured LAG.
-
Admin State Enabled — When checked, enables traffic forwarding through the selected LAG.
Reactivate Suspended LAG —When checked, reactivates a suspended LAG.
-
Auto Negotiation Enabled — When checked, enables the currently configured Auto Negotiation
setting. Auto-negotiation is a protocol between two link partners that enables a LAG to
advertise its transmission rate, duplex mode and flow control (the flow control default is
disabled) abilities to its partner.