Owner's Manual

382
SNTP -> Servers
With this screen, you can configure (adding or enabling) the SNTP servers. The SNTP Servers page
enables the device to request and accept SNTP traffic from a server.
Figure 13-121. SNTP Servers
Click Remove to delete a selected, listed item. When you click Add (or select an existing server
listed in the
SNTP Servers Settings portion of the screen and click Edit ) the SNTP Server Editor
opens (the lower portion of the screen) with the following fields:
-
SNTP Server —Enter a user-defined SNTP server IP addresses or hostname. Up to eight SNTP
servers can be defined. This field can contain 1 - 158 characters. It is read-only when you edit
listed servers.
-
Poll Interval —Enables polling the selected SNTP Server for system time information, when
enabled.
-
Encryption Key ID —Specifies the Key Identification for communication between the SNTP
server and device. The range is 1 - 4294967295.
SNTP Server Details (Read-only)
This section appears only when you edit an existing server setup.
-
Preference —The SNTP server providing SNTP system time information. The possible field
values are:
Primary—The primary server provides SNTP information.
Secondary—The backup server provides SNTP information.
- Status —The operating SNTP server status The possible field values are: