Owner's Manual

345
Stack Management -> Stack Configuration
This screen configures stack configuration for the selected device. On some devices, it consists of a
single checkbox to switch the master from Unit-1 to Unit-2. Check to activate this switch. Other
devices have a series of more complex screen.
Figure 13-93. Stack Management -> Stack Configuration
This screen has the following fields:
-
Unit ID —Select the identifier for the unit to be configured.
-
Change unit ID to —Enter the new identifier for the unit to be configured. Admin users can
renumber the switch ID of the selected switch. This field is nonconfigurable for users with
read-only access.
-
Master —Check if you want this unit to be a master (management) unit in preference to another
unit. The default value for this setting is Unassigned.
-
Management Status —Displays whether the selected switch is configured as the Master switch
(displays Management Unit) or a normal stacking member (Unassigned). The default value
for this setting is Unassigned.
-
Switch Type —Displays the switch type hardware ID.