Owner's Manual

342
- Interface — The interface number for which RMON statistics appear.
-
Counter Name — The selected MIB variable.
-
Counter Value — The value of the selected MIB variable.
-
Sample Type — Specifies the sampling method for the selected variable and comparing the value
against the thresholds. The possible field values are:
Delta— Subtracts the last sampled value from the current value. The difference in the val-
ues is compared to the threshold.
Absolute— Compares the values directly with the thresholds at the end of the sampling
interval.
- Rising Threshold — The rising counter value that triggers the rising threshold alarm.
-
Rising /Falling Event — Two fields that indicate the mechanism reporting alarms - LOG, TRAP,
or a combination of both. When you select LOG, no saving mechanism exists in either the
switch module or in the management system. However, if the switch module is not being
reset, it remains in the switch module LOG table. If you select TRAP, the trap’s general
mechanism generates and reports an SNMP trap. You can save the TRAP using the same
mechanism.
-
Falling Threshold — The falling counter value that triggers the falling threshold alarm. The
falling threshold is graphically presented on the bottom of the graph bars
-
Startup Alarm — The trigger that activates the alarm generation. Rising is defined by crossing the
threshold from a low-value threshold to a higher-value threshold.
-
Interval (sec) — Alarm interval time.
-
Owner — Switch module or user that defined the alarm.
Click
Apply to accept the edits you have configured and add it to the list. Cancel abandons your
edits.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.