Owner's Manual

311
This screen has the following fields:
-
DHCP Relay —Select from Enabled / Disabled .
DCHP Servers
Enter a DHCP server in the blank field next to Add , then click that button to list one here. Select a
listed server and click
Remove to delete it from the list.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.
UDP Relay
This screen controls UPD relay characteristics for the selected equipment.
Figure 13-69. UDP Relay
To create a new relay, or configure an existing selected one, click Add , or Edit , respectively. Once
you select a listed relay, you can click
Remove to delete it from the list. When you are adding or
editing a relay, the following fields appear in the editor below the list:
-
Source IP Interface —Select from those on the device in the pick list.
-
UPD Destination Port —Enter a destination port number (1 - 65535).
-
Destination Address —Enter the IP address of a permitted destination.
Click
Apply to accept your edits, or Cancel to abandon them. Click Configure to send any altered
configuration to the device. Click
Refresh to renew the device information on this screen.