Owner's Manual

303
Figure 13-61. ARP Interface Settings
Yo u c a n Edit ARP Interface settings for the selected device in this screen. Click Add to create a new
group of settings, or select an existing interface listed in the upper portion of the screen and click
Edit the editor opens (the lower portion of the screen) with the following fields:
-
Interface —The interface number of the port, LAG, or VLAN that is connected to the Ethernet
switch module.
-
IP Address —The station IP address, which is associated with the MAC address filled in below.
-
MAC Address —The station MAC address, which is associated in the ARP table with the IP
address.
-
Status —The ARP Table entry status. ( Static or Dynamic )
NOTE:
This screen is not available for all equipment.
Click Apply to accept the edits you have configured and add it to the list. Cancel abandons your
edits.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.