Owner's Manual

263
Bridge Settings
- Priority — (0-61440). Specifies the bridge priority value. When switches or bridges are running
STP, each are assigned a priority. After exchanging BPDUs, the switch with the lowest priority
value becomes the root bridge.
-
Hello Time — (1-10). Specifies the switch Hello time, which indicates the amount of time in
seconds a root bridge waits between configuration messages. The default value is 2.
-
Maximum Age (seconds) — Specifies the switch maximum age time, which indicates the
amount of time in seconds a bridge waits before implementing a topological change. The
default value is 20.
-
Forward Delay (seconds) — (4-30). Specifies the switch forward delay time, which indicates the
amount of time in seconds a bridge remains in a listening and learning state before forwarding
packets. The default value is 15.
Designated Root Status
- Bridge ID — Displays the bridge ID.
-
Root Bridge ID — Displays the root bridge ID.
-
Root Port — Displays port number that offers the lowest-cost path from this bridge to the root
bridge. It is significant when the bridge is not the root. The default is zero.
-
Root Path Cost — Displays the cost of the path from this bridge to the root.
-
Topology Changes Counts — Displays the total amount of STP state changes that have
occurred.
-
Last Topology Changes — Displays the total amount of time since the last topographic change.
The time is displayed in day/hour/minute/second format, for example, 0 day 5 hours 10
minutes and 4 seconds.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.