Owner's Manual

256
- Fast Link Operational Status —Indicates if Fast Link is enabled or disabled for the port or LAG.
If Fast Link is enabled for a port, the port is automatically placed in the forwarding state.
-
Point-to-Point Admin Status — Auto/Enable / Disable establishing a point-to-point link, or
specifies that the device to
auto matically establish a point-to-point link.
To establish communications over a point-to-point link, the originating PPP first sends Link
Control Protocol (LCP) packets to configure and test the data link. After a link is established
and the LCP negotiates any optional facilities, the originating PPP sends Network Control
Protocol (NCP) packets to select and configure one or more network layer protocols. When
each of the chosen network layer protocols has been configured, packets from each network
layer protocol can go over the link. The link remains configured for communications until
explicit LCP or NCP packets close the link, or until some external event occurs.
-
Point-to-Point Operational Status —The Point-to-Point operating state. This is the actual
device port link type.
-
Activate Protocol Migrational Test —When selected, enables PPP sending Link Control
Protocol (LCP) packets to configure and test the data link. It may differ from the
administrative state.
Click
Apply to accept the edits you have configured and add it to the list. Cancel abandons your
edits.
Click
Configure to send any altered configuration to the device. Click Refresh to renew the device
information on this screen.