Owner's Manual

253
GARP Settings
When equipment permits GARP settings, a screen with the following is available when you open a
port to edit (right-click on a port in the
Reference Tree details panel and select Open ).
Figure 13-21. GARP Settings
The following are fields on this screen. All are mandatory. Values are in centiseconds (hundredths of
a second), and are valid for ranges that vary according to device. A typical range would be between
2-2147483647 (except models 6224, 6248, see the tooltip on these fields for the accurate range).
-
GARP Join Timer— Range: 10 - 100
-
GARP Leave Timer— Range: 30 - 600 (must be at least three times the Join Timer figure.
-
GARP Leave All Timer— Range: 200 - 6000 (must be greater than the Leave Timer ).
NOTE:
This screen can also appear within the Group Operation Wizard. See Group Operations Wizard on page
691.
The Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.