Owner's Manual

248
- PVE —Appears only if enabled on the selected device and port.This is for 60xx devices, with
firmware v2.0 and above. Select from pick list. This enables a port as a Private VLAN Edge
(PVE) port. When a port is defined as PVE, it bypasses the Forwarding Database (FDB), and
forwards all Unicast, Multicast and Broadcast traffic to an uplink (except MAC-to-me
packets). Uplinks can be a port or LAG. Traffic from the uplink is distributed to all interfaces.
Port Security
- Port Security Locked / Enabled —Checkbox. Not on all device screens.
-
Intrusion Shutdown and Trap Shutdown —Select from the pick list. Value Values: none, trap,
shutdown, trap
and shutdown . Not on all device screens.
-
Dynamic Address Learning —Select from Enabled / Disabled . A tooltip reminds you that this
setting applies to all ports. Not on all device screens.
-
Action —Select from pick list. For example: Discard . Not on all device screens.
-
Trap Enabled —Check to enable security traps. Not on all device screens.
-
Trap Frequency —Enter a number of seconds between security traps. Not on all device screens.
The
Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.
Broadcast Control
If you enable broadcast control, the application validates ranges, depending on the device being
configured.