Owner's Manual

242
In the middle of this screen, you can add alternative TACACS+ servers to the default specified
above. Click
Add (or Edit if you want to edit a selected, existing server), and the TACACS+ Server
Editor
appears in the lowest panel on this screen. Click Delete to remove a listed, selected server.
Click
Apply to accept your server edits, and list the server, or Cancel to abandon those edits.
TACACS+ Server Editor
- IP Address —The address of the TACACS+ server.
-
Priority —The priority of this server
-
Authentication Port —The port for authentication
-
Status —A read-only indication of the server’s status (for example: not connected ).
-
Single Connection —Check to enable single connection
For the following radio buttons, you can either accept
Use Default , or specify your own: Source IP,
Key String,
and/or Timeout for Reply
The Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.
NOTE:
This screen can also appear within the Group Operation Wizard
Password Settings
This screen appears for several models (but not all) of Dell equipment.
Figure 13-13. Password Settings
The following are fields on this screen:
-
New Password —Encrypted password.