Owner's Manual

233
- IP Address Mode —Possible modes: Static, DHCP, BOOTP (does not appear in all screens). If
you select
Static mode, when it appears, it enables the following three fields (otherwise, these
are not write-able):
-
IP Address —The IP Address.
-
Net Mask / Subnet Mask —The net or subnet mask.
-
Gateway IP Address —The gateway’s IP address.
-
Port —Select a port from the pick list
-
LAG —Select a LAG from the pick list.
-
VLAN / Management VLAN —Select a VLAN from the pick list.
The
Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.
Management Security -> User Authentication
This screen is for all supported Dell equipment. The bottom panel is blank, and the Add, Edit,
Remove
buttons do not appear grayed out when you select a line in the table. If you click Add or
select a line and click Edit, the editor panel appears with editable fields for the line, described
below.
Figure 13-4. User Authentication
The screen displays current users on the switch. When editing or adding, columns and editor fields
below appear. following are fields on this screen (some may not appear for all devices):
-
User —Encrypted text, read-only once modified.
-
Password —Encrypted password.