Owner's Manual

182 Common Operations
Figure 11-11. Topology Presentation
The screens vary, depending on the entity you are editing, the following describes a representative
example. The
Contact -related screen displays the following:
Select the desired Graphic
- Node Graphic —Select the desired graphic when this entity appears in Topology screens from the
pick list. The contents of the next section (Mapping for Attributes in the Graphic) depends
on the graphic you select here. Installation seeds the available graphics on the pick list. If you
do not select a graphic, the application uses the default. You can click
Use Default to return a
selected graphic to the default.
If you select a
Link as the entity type, no such selection is possible. Nevertheless, in general terms,
you can configure the link’s attributes (
Pattern, Width, Color, Label and so on) as described below.