Users Guide
• Addition of Cluster Metrics in Dell Firmware Report
• Introduces SSD write endurance report
• Support for vROPS 6.7
• Introduces new Dashboard Enhancement
– Warranty heat-map for Dell EMC PowerEdge servers and Chassis
– vSAN enabled host pie-chart distribution
– Server and chassis health heat-map modied to report based on Dell reported overall health
Use case scenarios
This section describes typical use cases and tasks that can be performed with OpenManage Management Pack for vRealize Operations
Manager.
Monitoring the servers
Server monitoring is the process of reviewing and analyzing a server for health, inventory, availability, and other operations-related
processes. You can also monitor the components of servers such as CPU, memory, PSU, fan, temperature, physical disks, and so on.
For more information, see the Dell EMC servers overview dashboard.
Perform the following steps to monitor a server:
1 Launch the vRealize Operations Manager console.
2 From the Home tab, click Environment.
3 In Environment Overview, select Dell EMC OpenManage vRealize Operations Management Pack and click Dell EMC Servers.
4 Select the server that you want to monitor.
The health status, alerts, and the associated details of the selected server is displayed. For more information about alerts, see Viewing
Alerts.
NOTE
: NIC and FC does not support health monitoring, hence health is always shown as healthy.
Monitoring the chassis
Chassis monitoring is the process of reviewing and analyzing chassis level health, inventory, and availability of supported chassis connected
through OMIVV. You can monitor overall chassis health along with PSU and Fan’s health.
For more information, see the Dell EMC chassis overview dashboard.
Perform the following steps to monitor a chassis:
1 Launch the vRealize Operations Manager console.
2 On the Home tab, click Environment.
3 In Environment Overview, select Dell EMC OpenManage vRealize Operations Management Pack and click Dell EMC Chassis.
4 Select the chassis that you want to monitor.
The health status, alerts, and the associated details of the selected chassis is displayed. For more information about alerts, see Viewing
Alerts.
NOTE
:
If the PowerEdge FX2 chassis is not on the network, and the RSM mode is enabled in Chassis Management Controller, then the
chassis overall health alerts are not generated on the server.
OpenManage Management Pack for vRealize Operations Manager 5