Dell EMC OpenManage Management Pack for vRealize Operations Manager Version 2.1 Installation Guide October 2020 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Introduction................................................................................................................. 4 Pre-requisites....................................................................................................................................................................... 4 Compatibility Matrix............................................................................................................................................................
1 Introduction The OpenManage Management Pack for vRealize Operations Manager enables you to monitor the health status and analyze important metrics of the Dell EMC PowerEdge servers and chassis that are managed by OpenManage Integration for VMware vCenter (OMIVV) 4.0 or later.
2 Configure extended monitoring on OMIVV NOTE: OpenManage Management Pack supports multiple OMIVV adapter instances for single vROPS instance by following vRealize Operations Manager Sizing Guidelines. To configure Dell EMC OpenManage Integration for VMware vCenter (OMIVV) with vRealize Operations (vROPS), enable extended monitoring on OMIVV. To enable the extended monitoring support, perform the following steps: 1. Launch the OMIVV administration console. To launch the console, open a web browser https:\\<
3 Installing or upgrading To install or upgrade to OpenManage Management Pack for vRealize Operations Manager v2.1, perform the following steps: 1. Go to Dell.com/support. 2. Following are two ways to download vRealize Operations Manager v2.1: a. Enter the Service Tag of your Dell EMC Software Virtualization Solutions, and then select search. ● Select the appropriate model. ● On the support page of your server, select Drivers & Downloads.
3. Click Administration → Solutions. 4. To configure, click Solutions> Other Accounts> Add Account 5. Select your account type and click Dell OpenManage Management Pack for vRealize Operations Manager. 6. In New account information page OpenManage vRealize Operations Management Pack screen, perform the following steps: a. In instance Settings: i. In the Name box, enter a name for the adapter. ii. In the Description box, enter a description. b. In Connect Information: i.
NOTE: Disable the extended monitoring in OMIVV after deleting the instance if you do not want to monitor deleted instance in OMIVV. NOTE: Deleting may take few minutes depending upon the number of servers and chassis, managed by OMIVV.
4 Troubleshooting ● After I create and configure a new adapter instance, I am unable to see the firmware metrics. -Firmware metrics collection does not happen when the firmware catalog is getting refreshed. Run the inventory in OMIVV again, and check for the metrics after the next collect cycle. ● I still see the resources in unknown state once I delete the adapter instances.
