Owner's Manual

Post-Installation Configuration for Remote Enablement
This section details the steps to configure the dependent RPMs if you have installed the Remote Enablement feature.
The post-installation configuration script is available at /opt/dell/srvadmin/etc/ on the server file system.
After installing all the dependent RPMs and the Remote Enablement feature, execute the autoconf_cim_component.sh script.
Before executing the autoconf_cim_component.shscript,ensureDellOpenManageisinstalled.ForinformationoninstallingDellOpenManagesee,"Installing
Managed System Software."
Execute the following command to configure sfbc and openwsman as per the default configurations:
./ autoconf_cim_component.sh

Creating Server Certificate for WSMAN
You can either create a new certificate for WSMAN or reuse an existing certificate.

Creating a New Certificate
You can create a new server certificate for WSMAN by executing the owsmangencert.sh script located at /etc/openwsman. This script is provided by the
openwsman RPM. Follow the steps in the wizard to create the server certificate.

Reusing an Existing Certificate
If you have a self-signed or CA-signed certificate, you can use the same certificate for the openwsman server by updating the ssl_cert_file and ssl_key_file
values, grouped under [server] tag, in /etc/openwsman/openwsman.conf with your existing certificate values.

Configuring CRL for the openwsman Client
You need to configure the Certificate Revocation List (CRL) used by Server Administrator Web Server. To do this:

1. Mention a valid CRL file in /etc/openwsman/openwsman_client.conf.

2. If left blank, the CRL check is ignored.

Running sfcb and openwsman
Run sfcb and openwsman:
l /etc/init.d/sfcb start
l /etc/init.d/openwsmand start
On Red Hat Enterprise Linux 6 , for the sblim-sfcb and openwsman to start automatically after a reboot you need to change the run-levels using the chkconfig
utility. For example, if you want to run sblim-sfcb in run-levels 3 and 5, use the following command:
#chkconfig sblim-sfcb on --level 35
Refer to the operating system documentation for more details on chkconfig and its usage.
The managed system is configured and is ready to be used by the Server Administrator Web Server.

Winbind Configuration for openwsman and sfcb for Red Hat Enterprise Linux Operating
Systems
Follow the instructions mentioned below to configure openwsman and sfcb on 32-bit OMI installation. In case of a 64-bit installation, replace "lib" with "lib64".
NOTE: To configure Openwsman on the Managed Node to run on a different port, use the -p <port> option with autoconf_cim_component.sh. This is
optional and by default the Openwsman is configured to run on port 443.
NOTE: CRL support is only present on SUSE Linux Enterprise Server version 11 and Red Hat Enterprise Linux Server version 5 update 5. For other
operating systems, contact your operating system vendor to provide the required CURL library with CRL support.
NOTE: In Red Hat Enterprise Linux 6, replace sfcb with sblim-sfcb.