Owner's Manual
l libcmpiCppImpl0
l libwsman1
l openwsman-server
l sblim-sfcb
l sblim-sfcc
Installing Dependent RPMs
1. Check if the dependent RPMs are already installed. If yes, remove the installed RPMs.
2. Ensure that Pegasus RPMs are uninstalled.
3. Check if the openwsmand and sfcbd binaries are already installed using make-install. You can check by running the commands:
openwsman
or
sfcbd
or
You can check the existence of the above binaries in the /usr/local/sbin directory.
4. If the binaries are installed, uninstall these binaries.
5. Check for the required dependencies for the openwsman and sfcbd RPMs listed in Table7-3.
Table 7-3. Required Dependencies
6. Install the dependent RPMs.
You can install all the RPMs with a single command.
rpm -ivh rpm1 rpm2 rpm3 rpm4 ... rpmN
You can also install the RPMs individually.
rpm -ivh sblim-sfcb-x.x.x.rpm
rpm -ivh sblim-sfcc-x.x.x.rpm
rpm -ivh libwsman1-x.x.x.rpm openwsman-client-x.x.x.rpm
rpm -ivh openwsman-server-x.x.x.rpm
NOTE: In case of SLES 11 SP1 and Red Hat Enterprise Linux 6, it is recommended that you install the above RPMs from the operating system media.
Packages
Red Hat Enterprise Server
SUSE Linux Enterprise Server
Openwsman
l OpenSSL
l LibXML
l Pkgconfig
l CURL
l Chkconfig
l Initscript
l SBLIM-SFCC
l LibOpenSSL
l LibXML
l Pkg-config
l libCURL
l aaa_base
l aaa_base
l SBLIM-SFCC
SBLIM SFCC
CURL
LibCURL
SBLIM SFCB
l zlib
l CURL
l PAM
l OpenSSL
l Chkconfig
l Initscript
l zlib
l LibCURL
l PAM
l LibOpenSSL
l aaa_base
l aaa_base
NOTE: If you are installing RPMs individually, follow the sequence below.
NOTE: Install the libwsman and openwsman client RPMs simultaneously as they have cyclic dependency.