Owner's Manual

5. Enable SNMP using the following command:
vicfg-snmp.pl --server <server> --username <username> --password <password> -E

6. View the SNMP configuration using the following command:
vicfg-snmp.pl --server <server> --username <username> --password <password> -s

7. Test the SNMP configuration using the following command:
vicfg-snmp.pl --server <server> --username <username> --password <password> -T
Back to Contents Page

NOTE: The .pl extension is not required if you are using vSphere CLI on Linux or using vMA.