Owner's Manual

Configuring Protocols to Send Information to IT Assistant 251
4 Scroll down the list of services until you find SNMP Service , right-click
SNMP Service, and click Properties .
The
SNMP Service Properties window appears.
5 Click the Traps tab to add a community for traps or to add a trap
destination for a trap community.
6 To add a community for traps, type the community name in the
Community Name box and click Add to list .
7 To add a trap destination for a trap community, select the community
name from the
Community Name drop-down menu and click Add .
The
SNMP Service Configuration window appears.
8 Type the trap destination and click Add .
The
SNMP Service Properties window appears.
9 Click OK to save the changes.
Configuring SNMP Agent on Managed Systems
Running Supported Linux Operating Systems
This section describes the configuration of SNMP agents on systems
running Red Hat Enterprise Linux and SUSE Linux Enterprise Server
operating systems.
Managed system agents such as Server Administrator use the SNMP services
provided by the ucd-snmp or net-snmp SNMP agent. You can configure the
SNMP agent to change the community name, enable Set operations, and send
traps to an IT Assistant system. To configure your SNMP agent for proper
interaction with IT Assistant, perform the procedures described in the following
sections.
NOTE: See your operating system documentation for additional details on SNMP
configuration.
NOTE: See the VMware Basic Administration Guide on the Dell Support website at
support.dell.com/manuals for information on configuring SNMP agent on managed
systems running ESX Server.