Users Guide

102 Configuring Protocols to Send Information to IT Assistant
5 Select Specified Community May Read .
6 Under Monitor Community , enter the read community name.
7 Select Control State to configure the write (or set) community name.
The
Control Community Handling menu appears with the following options:
• Any Community May Write
• Leave as Default Setting
• No Community May Write
• Specified Community May Write
NOTE: Press <F1> for more information about Control State. Press <Esc> to clear the help window.
8 Select Specified Community May Write .
9 Under Control Community , enter the write community name.
10 Select Trap State to configure trap community handling.
The
Trap Handling menu choices appears with the following options:
• Do Not Send Traps
• Leave as Default Setting
• Send Traps With Specified Community
11 Select Send Traps With Specified Community .
12 Under Trap Community , enter the community name you wish the traps to have.
NOTE: : Press <F1> for more information about Trap State. Press <Esc> to clear the help window.
13 Press <Esc> to exit the SNMP Parameters menu.
A message box appears, prompting you to save changes.
14 Select Yes .
The
Manage Configuration menu appears.
15 Press <Esc> to exit the Manage Configuration menu.
The
Internetworking Configuration menu appears.
16 Select Protocols .
The
Protocol Configuration menu appears.
17 Select the TCP/IP .
The
TCP/IP Protocol Configuration menu appears.