Users Guide
Table Of Contents
- Dell EMC OpenManage Integration Version 2.0 with Microsoft Windows Admin Center User’s Guide
- Contents
- Overview of OpenManage Integration with Microsoft Windows Admin Center
- Getting started with OpenManage Integration with Microsoft Windows Admin Center
- Ports required by Dell EMC OpenManage Integration with Microsoft Windows Admin Center
- Manage Dell EMC PowerEdge Servers
- Manage Failover clusters, Azure Stack HCI, and Windows Server HCI clusters
- View iDRAC details of the PowerEdge servers and nodes of HCI and Failover clusters
- Update PowerEdge servers and nodes of Windows Server HCI, Azure Stack HCI, and Failover clusters using OpenManage Integration extension
- Integrated deploy and update of Azure Stack HCI clusters
- Full Stack Cluster-Aware Updating for Azure Stack HCI clusters using OpenManage Integration snap-in
- Troubleshooting
- Identifying the generation of your Dell EMC PowerEdge server
- Contacting Dell EMC
- Glossary
- Appendix
● Devices with iDRAC firmware version less than 3.30.30.30. Update the iDRAC firmware to the latest version to enable blink
and unblink operations.
○ If blink and unblink operation is unavailable for selected supported disks even with iDRAC firmware version 3.30.30.30
and above, then upgrade the iDRAC firmware to the latest version to enable blink and unblink operations.
NOTE:
● When the blink or unblink operation is running, Refresh button to load the latest health and hardware inventory
information is disabled. And, when the health and hardware inventory is loaded in OMIMSWAC, blink and unblink
operations is disabled.
● Blink or unblink operation fails on physical disks that are attached to an embedded SATA controller with an error
Blink/Unblibk May not be supported with - <disk_name>.
Manage Failover clusters, Azure Stack HCI, and Windows Server HCI clusters 17