Users Guide

Appendix
SAS-RAID_Driver
While performing update compliance operation for SAS-RAID_Driver, ensure that SATA controller and NVMe PCIe SSDs are set to RAID
mode. To configure RAID mode:
1. When the Dell Power-On Self-Test (POST) screen is displayed, press F2.
Dell PowerEdge System Setup window is displayed.
• Under System BIOS setting , configure RAID mode in SATA settings > Embedded SATA.
• Under System BIOS setting , configure RAID mode in NVMe settings > NVMe mode.
Recommended catalog for target nodes or clusters
The following table shows the recommended catalog for a target node or cluster under 'Update Source'.
Target nodes or cluster
Recommended catalog
PowerEdge server (Rack, Modular, and Tower) Online (HTTPs) - Dell EMC Enterprise Catalog (for PowerEdge
servers)
MX server Online (HTTPs) - Dell EMC MX Solution Catalog (for PowerEdge
servers)
AHCI cluster ready nodes (S2D or Ax appliance) Online (HTTPs) - Dell EMC Azure Stack HCI Solution Catalog
Cluster containing MX and PowerEdge server Online (HTTPs) - Dell EMC Enterprise Catalog (for PowerEdge
servers)
Cluster containing AHCI ready nodes and PowerEdge server Online (HTTPs) - Dell EMC Enterprise Catalog (for PowerEdge
servers)
Cluster containing PowerEdge, MX, and AHCI ready node server Online (HTTPs) – Dell EMC Enterprise Catalog (for PowerEdge
servers)
PowerEdge XE2420 Edge server or cluster Online (HTTPs) - Dell EMC Enterprise Catalog (for PowerEdge
servers)
B
36 Appendix