Release Notes

Known issues

Issue 1

Description

Unable to fetch the health and hardware inventory from target iDRAC.

Workaround

Ensure the following are enabled or available on the target node.

• The Redfish service is enabled.

• An iDRAC user slot is available.

• SMB port 445 is open. For more information, see https://go.microsoft.com/fwlink/?linkid=2101556.

• For management of PowerEdge servers, OMIMSWAC uses an internal OS to iDRAC Pass-through interface. By default, iDRAC will be

reachable using the IP address 169.254.0.1/<Subnet> or 169.254.1.1/<Subnet>. However, if the host has another network interface in

the same subnet (For example, when tool like VMFleet is installed), OMIMSWAC might not be able to communicate to the iDRAC from

the host OS. To resolve the conflict, log in to iDRAC and change the USB NIC IP address under the OS to iDRAC passthrough section.

For more information about assigning this IP address, see the iDRAC documentation on the Dell EMC support site.

• Ensure that the target node is not booted to Lifecycle Controller.

• Target node is not in the reboot state, or is powered-off.

• The USB NIC adapter is not disabled on the target node OS.

• PowerShell execution policy is set to RemoteSigned in the target node OS. For more information, see https://www.dell.com/support/

article/sln318718/dell-emc-openmanage-integration-with-microsoft-windows-admin-center-omimswac-fails-to-query-host-

information.

Issue 2

Description

For YX2X and YX3X models of PowerEdge servers with firmware versions lesser than 2.60.60.60, and YX4X models of PowerEdge

servers with firmware versions lesser than 3.30.30.30, information of the following components are not displayed:

• Health status: memory, storage controllers, storage enclosures, and physical disks.

• Hardware inventory: memory, storage controllers, storage enclosures, physical disks, network devices, and firmware.

Workaround

• Ensure that the YX2X and YX3X models of PowerEdge servers are updated with latest iDRAC version of 2.60.60.60 or later.

• Ensure that the YX4X models of PowerEdge servers are updated with latest iDRAC version of 3.30.30.30 or later.

Issue 3

Description

The overall health status of the PowerEdge servers and HCI cluster might be displayed as critical or warning even though the components

of the nodes displayed on the Windows Admin Center are healthy.

Workaround

For more details on the components in critical health state, go to the respective iDRAC console.

Issue 4

Description

Known issues 7