Users Guide

○ Disks associated to Boot Optimized Storage Subsystem (BOSS) cards.
○ Devices with iDRAC firmware version less than 3.30.30.30. Update the iDRAC firmware to the latest version to
enable blink and unblink operations.
NOTE:
○ When the blink or unblink operation is running, Refresh button to load the latest health and hardware inventory
information is disabled. Also, when the health and hardware inventory is being loaded in OMIMSWAC, blink and
unblink operations is disabled.
○ Blink or unblink operation fails on physical disks that are attached to an embedded SATA controller with an error
Blink/Unblibk May not be supported with - <disk_name>.
• Power Supplies
• Fans
To view the latest hardware inventory information, in the upper-right corner of the Inventory tab, click Refresh.
To view iDRAC details of target node, see View iDRAC details of the PowerEdge servers and nodes of HCI and Failover clusters on page
16.
NOTE: Under Inventory, the attribute values of a few target node components are displayed as blank because the value
might not be available in the target node.
NOTE: Under Firmware inventory, for few network devices with multiple ports, since the applicable firmware version is
same for all ports, only a single port with the firmware version will be displayed.
NOTE: Information of few attributes of storage enclosures, firmware inventory, and memory component might not be
available for:
• YX2X and YX3X models of PowerEdge servers.
• YX4X models of PowerEdge servers with iDRAC version lesser than 3.30.30.30.
NOTE: For PCIe SSD Backplane of storage enclosures, few attribute values might not be available.
NOTE: Health status information is available for Accelerators in YX4X models of PowerEdge servers and above with
iDRAC version 4.00.00.00 or newer.
NOTE: Intel DIMM memory is identified as IntelPersistent with an icon.
12 Manage Dell EMC PowerEdge Servers