Users Guide
The Part Replacement Configuration window is displayed.
2. Select the servers’ whose component you want to configure, and then click Part Replacement.
NOTE: The option name expands to Configure Part Replacement when you hover over to Part Replacement.
The Part Replacement Configuration window is displayed.
Polling and notification
1. In OMIMSSC, click Maintenance Center, and then click Polling and Notification.
2. Click Polling and Notification.
Launch iDRAC
1. In OMIMSSC, expand Configuration and Deployment, and select one of the following:
• Click Server View. Based on the server (if it is a host or an unassigned server), click Unassigned Servers or Hosts tab, and click
the iDRAC IP address of the server.
The Unassigned Servers tab is displayed by default.
To view the hosts tab, click Hosts.
• Click Cluster View. Expand the cluster type and expand cluster group to server level.
The Server tab is displayed.
2. To launch iDRAC console, click IP address.
3. To launch iDRAC console, click IP address.
Launch Input Output Module
To launch Input Output Module console, perform the following steps:
1. In OMIMSSC, expand Configuration and Deployment, click Modular Systems View. Expand the model to individual devices level.
All devices under that model are displayed.
2. Click I/O Modules tab.
3. Click IP address of the device.
Resolving synchronization errors
1. In OMIMSSC, click Configuration and Deployment, click Server View, and then click Resolve Sync Errors.
2. Click Resolve Sync Errors.
Synchronizing OMIMSSC with enrolled Microsoft
console
1. In OMIMSSC, click Configuration and Deployment, click Server View, and then click Synchronize with OMIMSSC to
synchronize all the hosts that are listed in enrolled MSSC with the OMIMSSC Appliance.
2. To synchronize all the hosts that are listed in the enrolled MSSC with Appliance, click Synchronize with OMIMSSC.
Synchronization is a long running task. View the job status in Jobs and Logs page.
Assign and deploy
In OMIMSSC, click Configuration and Deployment, and then click Server View. Select the servers on which you want to deploy a
template on, and then click Deploy Operational Template.
The Deploy Operational Template page is displayed.
Configuration and deployment
61