Setup Guide

If you want to store the VM in a dierent location, then select Store the virtual machine in a dierent location, click Browse,
and traverse to the new location.
d In Specify Generation, select Generation 1, and then click Next.
e In Assign Memory, assign the memory capacity mentioned in the prerequisite.
f In Congure Networking, in Connection, select the network that you want to use, and then click Next.
g In Connect Virtual Hard Disk, select Use an existing virtual hard disk, traverse to the location where the OMIMSSC—v7 VHD
le is present, and select the le.
h In Summary, conrm the details that you have provided and click Finish.
i Set the Number of virtual processors count value to 2, since by default the processor count is set to 1.
To set the processor count:
1 Right-click Appliance, and select Settings.
2 In Settings, select Processor, and set Number of virtual processors to 2.
2 To verify that the Appliance VM is congured appropriately, select and then right-click the Appliance VM, click Settings, and then
perform the following tasks:
a Check if the allocation of memory for the Appliance is as per the requirement mentioned in the Common requirements. Else
provide the memory in Startup RAM, and click Apply.
b Check if the processor count is as per the requirement mentioned in the Common requirements. Else provide the number of
processor counts in Number of Virtual processors count under Processors.
c Check if the Virtual hard disk eld under IDE Controller: IDE Controller 0 > Hard Drive the Virtual hard disk referring to the
OMIMSSC—v7 le else, click Browse and navigate to the location where the VHD le is unzipped and select the OMIMSSC—
v7 le and click Apply.
d Check if Network Adapter > Virtual Switch is connected to a physical NIC card, else congure the NIC card, and select the
appropriate NIC card from the Virtual Switch drop-down menu and click Apply.
3 From the Hyper-V Manager menu, right-click the Appliance VM and perform the following tasks:
a Click Connect, and then click Start.
If the newly created virtual machine with the selected virtual hard disk of Appliance fails to boot with any kernel panic exception, edit
the virtual machine settings, and enable the dynamic memory option for this virtual machine.
To enable the dynamic memory option for a virtual machine, perform the following tasks:
a Right-click the Appliance VM, click Settings, and then click Memory.
b Under Dynamic Memory, select the Enable Dynamic Memory check box, and provide the details.
4 Perform the following tasks once Appliance starts:
NOTE
: It is recommended that you wait for ve minutes before you log in as an Admin so that all services are initiated.
a In localhost login: Type admin.
b In Enter new Admin password: Type a password.
c In Please conrm new Admin password: retype the password, and press Enter to continue.
d In Appliance, select Congure Network, press Enter, and perform the following substeps:
1 In Select Action, select DNS conguration, and press Enter.
2 In DNS conguration, in Hostname, type the FQDN of the host, and then press OK.
For example, Hostname.domain.com
NOTE
: You can change the IP address of Appliance by selecting Device conguration option. You
cannot change the IP address or host name of Appliance after this point.
3 In Select Action, press Save&Quit.
e (Optional) If you plan to use multiple SCCMs and SCVMMs, provide the number of consoles you plan to enroll in the Congure
Enrollment Params option by proving the details.
f From Appliance, note the admin portal URL.
16
Installing, conguring and maintaining OMIMSSC