Users Guide

Table 28. Hardware inventory information
Hardware
inventory:
Component
Navigation through OMIVV Information
Inventory, and then click
Fans.
● Warning Threshold
● Critical Threshold
○ Minimum
○ Maximum
● Pulse Width Modulation (Only for MX chassis)
NOTE: In an MX chassis, the presence of a fan is indicated as
'Yes' even when a fan is removed from the chassis. However,
the fan health is displayed as Critical on the Summary page
with active error.
Power supplies Use either of the following
methods:
● In the Overview tab, click
Power Supplies.
● In the Monitor tab, expand
the left pane, click Hardware
Inventory, and then click
Power Supplies.
Information about power supplies:
● Name
● Capacity
● Present
● Power state
● Input Voltage (Only for MX chassis)
Temperature
sensors
Use either of the following
methods:
● In the Overview tab, click
Temperature Sensors.
● In the Monitor tab, expand
the left pane, click Hardware
Inventory, and then click
Temperature Sensors.
Information about temperature sensors:
● Location
● Reading
● Warning threshold
○ Maximum
○ Minimum
● Critical threshold
○ Maximum
○ Minimum
NOTE: For PowerEdge M1000e chassis, information about the
temperature sensors is displayed only for chassis. For other
chassis, information about the temperature sensors is displayed
for chassis and associated modular servers.
I/O modules Use either of the following
methods:
● In Overview tab, click I/O
Modules.
● In Monitor tab, expand the
left pane, click Hardware
Inventory, and then click I/O
Modules.
Information about I/O modules:
● Slot/Location
● Present
● Name
● Fabric
● Service Tag
● Power Status
To view additional information, select the corresponding I/O
module and the following information is displayed:
● Role
● Firmware version
● Hardware version
● IP address
● Subnet mask
● Gateway
● MAC address
● DHCP enabled
104 Chassis management