Users Guide

a. On the Date and Time tab, select the Synchronize date and time over the network check box. The Synchronize
date and time over the network check box is enabled only after NTP is configured successfully using the Admin portal.
For more information about configuring NTP, see Set up Network Time Protocol servers on page 20.
b. Click Time Zone and select the applicable time zone, and then click OK.
6. To configure network of the OMIVV appliance, click Network Configuration.
To manage the Dell EMC servers in your vSphere environment, OMIVV requires access to both the vSphere network
(vCenter and ESXi management network) and out-of-band network (iDRAC, CMC, and OME-Modular).
If vSphere network and out-of-band network are maintained as separate isolated network in your environment, OMIVV
requires access for both the networks. In this case, OMIVV appliance must be configured with two network adapters. Dell
EMC recommends configuring both the networks as part of the initial configuration.
If you can access the out-of-band network using the vSphere network, do not configure two network adapters for the
OMIVV appliance. For more information about configuring a second NIC, see Configure OMIVV appliance with two network
adapters on page 25.
7. Select Wired Connection 1 and click
.
a. Click the IPv4 Settings tab, select Manual from the Method drop-down list, and click Add.
NOTE:
If you select Automatic (DHCP), do not enter any IP address because the OMIVV appliance will automatically
receive IP from the DHCP server during the next restart.
b. Enter a valid IP, netmask (in the Classless Inter-Domain Routing (CIDR) format), and gateway information.
If you enter an IP address in the Netmask box, it is automatically converted to its respective CIDR format.
c. Enter the DNS server IP and domains to be searched for respectively in the DNS Servers and Search Domains boxes
respectively.
d. Select the Require IPV4 addressing for this connection to complete check box and click Save.
24
About Administration Console