Setup Guide
Table Of Contents
- OpenManage Integration for VMware vCenter Quick Install Guide for vSphere Client Version 3.1
- Installing OpenManage Integration for VMware vCenter
- Installation introduction
- Prerequisites
- Upgrading OpenManage Integration Plugin from 3.0 version to the current version
- Migration Path to migrate from 2.x to 3.1
- Recover OpenManage Integration for VMware vCenter if the older plug-in is unregistered
- Installation introduction
- Configuring OpenManage Integration for VMware vCenter
- Configuration Wizard welcome page
- Creating a new Connection Profile [Wizard]
- Configuring Events And Alarms [Wizard]
- Setting Up A Proxy Server [Wizard]
- Scheduling Inventory Jobs [Wizard]
- Running A Warranty Retrieval Job [Wizard]
- Configuring the Deployment Credentials [Wizard]
- Setting The Default Firmware Update Repository [Wizard]
- Enabling The OMSA Link [Wizard]
- Configuring Dell iDRAC Auto-Discovery
- Configuring NFS Shares
- Licensing in OpenManage Integration for VMware vCenter
- More Configuration Information
- Related documentation and resources
If the IP address of the new OpenManage Integration version 3.1 appliance has changed from that of the old appliance,
the trap destination for the SNMP traps must be configured to point to the new appliance. For 12th generation and
higher generation servers, this is fixed by running the Inventory on these hosts. For hosts earlier than 12th generation
that were compliant with earlier versions, this IP change shows up as noncompliant and requires you to configure OMSA.
Recover OpenManage Integration for VMware vCenter
if the older plug-in is unregistered
If you have unregistered the plug-in after taking backup of the database of the older version, perform the following steps before
proceeding with the migration.
NOTE: Unregistering the plug-in removes all the customizations that were implemented on the registered alarms by the
plug-in. The following steps do not restore the customization. However, it re-registers the alarms in their default state.
1. Perform step 3 through step 5 in Migration Path to migrate from 2.x to 3.1 on page 12.
2. Register the plug-in to the same vCenter that you had registered in the older plug-in.
3. Complete step 6 through step 8 in Migration Path to migrate from 2.x to 3.1 on page 12 to complete the migration.
Installing OpenManage Integration for VMware vCenter 13