White Papers
Table Of Contents
- 1 Introduction
- 2 Baselining and remediation in OMIVV
- 3 Baselining using VMware vSphere Lifecycle Manager
- 1.1
- 1.1
- 1.1
- 3.1 Register vSphere Lifecycle Manager in OMIVV
- 3.2 Prerequisites to use OMIVV as HSM in vSphere Lifecycle Manager
- 3.3 Associate OMIVV as HSM in vSphere Lifecycle Manager image
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 1.1
- 3.4 Examine drift status and resolution
- 1.1
- 1.1
- 1.1
- 1.1
- 3.5 Pre-Check
- 1.1
- 1.1
- 3.6 Remediation in vSphere Lifecycle Manager
- 1.1
- 1.1
- 1.1
- 3.7 vSAN Hardware Compatibility Listing (HCL)
- 4 Common issues when using OMIVV as a Hardware Support Manager
- 1
- 1
- 1
- 5 Conclusion
- 6 Technical Support and Resources
24 Dell EMC OMIVV as a Hardware Support Manager for VMware vSphere Lifecycle Manager
Issue 5: The cluster is managed using vSphere Lifecycle Manager with HSP. The firmware repository profile
that is associated with the cluster profile in OMIVV or HSP version is modified. In this case, if you run the
check compliance in vSphere Lifecycle Manager, shows following error: “Unable to find the cluster profile with
provided version.”
Figure 22: Firmware compliance error message
Resolution: Edit the vSphere Lifecycle Manager image, edit the “Firmware and Driver Addon”, and then
select the HSP (this time it will be shown with updated version because of the changes you have done for
firmware repository that is associated with cluster profile) and save the image.
Figure 23: vSphere Lifecycle Manager image edit option