Install Guide

NOTE:
Sometimes, after you configure the OMIVV appliance with a static IP, the OMIVV terminal utility page does not
immediately refresh and display the updated IP. To resolve this issue, exit the OMIVV terminal utility, and then log in
again.
8. To change the hostname of the OMIVV appliance, click Change Hostname.
a. Enter a valid hostname, and click Update hostname.
NOTE:
If any vCenter servers are already registered with the OMIVV appliance, unregister and re-register all the
vCenter instances. For more information, see Manage un-registration and re-registration on page 35.
9. Restart the appliance.
Set up Network Time Protocol servers
You can use Network Time Protocol (NTP) to synchronize the OMIVV appliance clocks to that of an NTP server.
1. On the APPLIANCE MANAGEMENT page, click Edit in the NTP Settings area.
2. Select Enabled. Enter the hostname or IP address of a preferred and secondary NTP server and click Apply.
3. After configuring NTP, start the terminal console and select the Sychronize date and time over the network check box.
NOTE: It might take around 10 minutes for the OMIVV clocks to synchronize with the NTP server.
20 Install and configure OMIVV