Users Guide

The AD credential can be either same or separate for both the iDRAC and hosts.
d. In the Host Root area, enter the local host credentials or AD credentials.
The default username is root.
● To enter the local host credentials, perform the following:
○ Enter password.
Host password is required only for hosts running ESXi 6.5 U3 and earlier versions.
To skip this step for ESXi 6.7 and later versions, ensure that the Use Host Credentials check box is cleared. If
password is entered for host running ESXi 6.7 and later, the password is ignored.
For hosts running ESXi 6.7 and later versions, it is not required to enter the ESXi credentials. OMIVV can pair the
iDRAC with its ESXi host even if incorrect host credentials are entered.
● To enter the credentials for hosts that are already configured and enabled for AD, select the Use Active Directory
check box.
○ Enter the username in the Active Directory User Name box. Enter the username in one of the formats such as
domain\username or username@domain. The username is limited to 256 characters. See the Microsoft
Active Directory Documentation for username restrictions.
○ Enter password.
● To download and store the host certificate and validate it during all future connections, select the Enable
Certificate Check check box.
5. Click Next.
The Select Hosts page is displayed.
6. On the Select Hosts page, expand the tree view and select the hosts, and then click OK.
● To add or remove hosts from the Associated Hosts page, click ADD HOST
NOTE:
Do not add a PowerEdge MX server with a disabled iDRAC IPv4 to a host credential profile. These servers
are managed using a chassis credential profile.
The selected hosts are displayed on the Associated Hosts page.
7. To test the connection, select one or more hosts, and click BEGIN TEST.
It is recommended that you test the connection for all configured hosts.
During test connection, OMIVV enables the WBEM service and then disables after retrieving iDRAC IP for hosts running
ESXi 6.5 and later.
NOTE:
After you enter valid credentials, the test connection operation may fail for host, and a message is displayed
indicating that invalid credentials are entered. This issue is observed if ESXi is blocking the access. Multiple attempts to
connect the ESXi by using incorrect credentials blocks you from accessing ESXi for 15 minutes. Wait 15 minutes, and
retry the operation.
● To stop the test connection process, click ABORT TEST.
You can view the test connection results in the TEST RESULTS section.
8. Click Finish.
Edit host credential profile
You can edit the credentials of multiple host credential profiles at a time.
1. On the Name and Credentials page, do the following:
a. Edit the profile name and description.
b. In the iDRAC Credentials area, edit the iDRAC local credentials or AD credentials.
● To change the local credentials of iDRAC, perform the following tasks:
○ Change the username in the User Name box. The username is limited to 16 characters.
For information about defining username, see the iDRAC User's Guide available at dell.com/support.
Manage hosts using host credential profile
39