Users Guide

2. To automatically open the iDRAC console, click Launch iDRAC GUI.
3. Navigate to the user list in the iDRAC console, and click one of the following:
● iDRAC7: Select iDRAC settings > Users tab.
● iDRAC8: Select iDRAC settings > Users tab.
● iDRAC9: Select iDRAC settings > Users tab.
For iDRAC 7 and 8:
a. To edit the settings, in the User ID column, click the link for the admin (root) user.
b. Click Configure User, and then click Next.
c. In the User Configuration page for the selected user, select the check box next to Enable user, and then click Apply.
For iDRAC9:
a. Select the root user and click Enable.
Does OMIVV support VMware vCenter server appliance
Yes, OMIVV supports the VMware vCenter Server appliance since v2.1.
A server may show as non-compliant with CSIOR status,
"Unknown"
Resolution: An unknown CSIOR state indicates a non-responsive iDRAC on the host. A manual iDRAC reset on the host fixes this
issue.
Version Affected: All
Firmware level not updated when I have performed firmware
update with Apply on Next reboot option and system was rebooted
To update firmware, run the inventory on the host after the reboot is completed. Sometimes, where the reboot event does not
reach the appliance, the inventory is not automatically triggered. In such situation, you must rerun the inventory manually to get
the updated firmware versions.
Host still displayed under chassis even after removing host from
vCenter tree
The hosts under the chassis are identified as part of the chassis inventory. After a successful chassis inventory, the host list
under the chassis is updated. Even if the host is removed from the vCenter tree, the host is displayed under the chassis until the
next chassis inventory is run.
After backup and restore of OMIVV, alarm settings are not
restored
Restoring the OMIVV appliance backup does not restore all the Alarm settings. However, in the OpenManage Integration for
VMware GUI, the Alarms and Events field displays the restored settings.
Resolution: In the OMIVV GUI, in the Settings tab, manually change the Events and Alarms settings.
Frequently Asked Questions-FAQ
155