Users Guide

WARNING: Do not use "+" to add any new network interface. It is mandatory to use the vSphere Edit Settings to add
a NIC.
6.
Select the NIC that you want to configure and click
.
7. To identify the correct NIC, use the MAC ID displayed on the Ethernet tab, and then compare it against the MAC ID displayed in the
vSphere Client (HTML-5).
Ensure that you do not change the default MAC address that is listed in the Ethernet tab.
8. Click the General tab and select the Automatically connect to this network when it is available check box.
9. Click the IPv4 Settings tab and do the following:
About Administration Console
27