Users Guide

Information Description
• Remaining Rated Write Endurance—displays the SSD remaining write
endurance.
• Connector ID—displays the connector ID.
• Enclosure ID—displays the enclosure ID.
• Device ID—displays the device ID.
• Model—displays the model number of the physical storage disk.
• Part Number—displays the storage part number.
• Serial Number—displays the storage serial number.
• Vendor—displays the storage vendor name.
Controllers
• Controller ID—displays the controller ID.
• Name—displays the name of the controller.
• Device FQDD—displays the FQDD of the device.
• Firmware Version—displays the firmware version.
• Minimum Required Firmware—displays the minimum required firmware. This
column is populated if the firmware is out of date and a newer version is available.
• Driver Version—displays the driver version.
• Patrol Read State—displays the Patrol Read State.
• Cache Size—displays the cache size.
NOTE: This section displays the chipset controller information. This is not
displayed in the storage controller section of iDRAC UI, but you can view
this information about the inventory page of iDRAC.
Enclosures
• Controller ID—displays the controller ID.
• Connector ID—displays the connector ID.
• Enclosure ID—displays the enclosure ID.
• Name—displays the name of the enclosure.
• Device FQDD—displays the device FQDD.
• Service Tag—displays the service tag.
View firmware information of a single host
The following firmware-related information is displayed:
• Name—displays the name of all the firmware on this host.
• Type—displays the type of firmware.
• Version—displays the version of all the firmware on this host.
• Installation Date—displays the installation date.
NOTE:
When the hosts are managed using the chassis credential profile, the firmware inventory data show few extra
components such as Life Cycle Controller and Software RAID.
You can launch firmware update and configure system lockdown mode wizards from this page.
View power monitoring information of a single host
You can view the information such as general information, thresholds, reserve power capacity, and energy statistics.
• General Information—displays the Power Budget and Current Profile name.
• Threshold—displays the Warning and Failure thresholds in watts.
• Reserve Power Capacity—displays the Instant and Peak reserve power capacity in watts.
Energy Statistics
• Type—displays the energy statistics type.
• Measurement Start Time (Host Time)—displays the date and time when the host began to consume power.
• Measurement Finish Time (Host Time)—displays the date and time when the host stopped to consume power.
•
NOTE: The host time, as used here, means the local time where the host is located.
104 Host Management