Install Guide

• If the required deployment mode is already set, a message is displayed.

5 If the deployment mode is changed, conrm the changes, and then proceed with rebooting the OMIVV appliance to allow the

deployment mode to be updated.

NOTE: During the OMIVV appliance boot up, the allocated system resource is veried against the set deployment mode. If the

allocated system resources are less than the set deployment mode, the OMIVV appliance does not boot up to the login screen.

To boot up the OMIVV appliance, shut down the OMIVV appliance, update the system resources to the existing set deployment

mode, and follow the downgrade deployment mode task.

Downgrading deployment mode

1 Log in to the Administration Console.

2 Change the deployment mode to the desired level.

3 Shut down the OMIVV appliance and change the system resources to the desired level.

4 Turn-on the OMIVV appliance.

BIOS, iDRAC, Lifecycle Controller versions

The BIOS, iDRAC, and the Lifecycle Controller versions required to enable the features of OpenManage Integration for VMware vCenter are

listed in this section.

It is recommended that you use the Bootable ISO created by using Repository Manager, or Lifecycle Controller's Platform to update your

servers to one of the following base versions before using OMIVV:

NOTE

: It is recommended to use Dell EMC OpenManage Enterprise-Modular Edition Version 1.00.01 with OMIVV 4.3.

Table 2. BIOS for PowerEdge 11

generation servers

Server Minimum version

PowerEdge R210 1.8.2 or later

PowerEdge R210II 1.3.1 or later

PowerEdge R310 1.8.2 or later

PowerEdge R410 1.9.0 or later

PowerEdge R415 1.8.6 or later

PowerEdge R510 1.9.0 or later

PowerEdge R515 1.8.6 or later

PowerEdge R610 6.1.0 or later

PowerEdge R710 6.1.0 or later

PowerEdge R715 3.0.0 or later

PowerEdge R810 2.5.0 or later

PowerEdge R815 3.0.0 or later

PowerEdge R910 2.5.0 or later

PowerEdge M610 6.1.0 or later

PowerEdge M610x 6.1.0 or later

Introduction 9