Users Guide

Why is host still displayed under chassis even after
removing host from vCenter tree?
The hosts under the chassis are identified as part of the chassis inventory. After a successful chassis inventory, the host list under the
chassis is updated. Therefore, even if the host is removed from the vCenter tree, the host is displayed under the chassis until the next
chassis inventory is run.
In Administration Console, why Update Repository Path is
not set to default path after I reset appliance to factory
settings?
After you reset the appliance, go to the Administration Console, and then click APPLIANCE MANAGEMENT in the left pane. In the
Appliance Settings page, the Update Repository Path is not changed to the default path.
Resolution: In Administration Console, manually copy the path in the Default Update Repository field to the Update Repository
Path field.
After backup and restore of OMIVV, why alarm settings
are not restored?
Restoring the OMIVV appliance backup does not restore all the Alarm settings. However, in the OpenManage Integration for VMware GUI,
the Alarms and Events field displays the restored settings.
Resolution: In the OpenManage Integration for VMware GUI, in the Manage > Settings tab, manually change theEvents and Alarms
settings.
Hypervisor deployment fails when NIC Partitioning
(NPAR) is enabled on a target node and disabled in System
Profile
Hypervisor deployment fails when a System Profile with a disabled NPAR is applied on a target machine. Here, NPAR is enabled on the
target node and only one of the partitioned NIC, except partition 1 is selected as the NIC for the Management Tasks during the
deployment process through the deployment wizard.
Resolution: If you are changing the NPAR status through System Profile during deployment, ensure that you select only the first partition
for management network in the deployment wizard.
Version Affected: 4.1
Available virtual appliance version displays wrong
information when the available version is lesser than the
current version
In the OMIVV Admin console, under Appliance Management, Available Virtual Appliance Version displays the modes RPM and OVF
as available.
NOTE:
It is recommended that update repository path is set to the latest version and downgrading the virtual appliance
version is not supported.
Bare-metal deployment issues
This section deals with issues found during the deployment process.
128
Troubleshooting