Setup Guide

If the IP address of the new OMIVV version 4.0 appliance is changed from the old appliance, configure the trap
destination for the SNMP traps to point to the new appliance. For 12th generation and higher generation servers, the
IP change is fixed by running inventory on these hosts. For hosts earlier than 12th generation that were compliant
with earlier versions, the IP change is displayed as noncompliant and requires you to configure Dell OpenManage
Server Administrator (OMSA). For more information on fixing the host compliance, see Reporting and fixing
compliance for vSphere hosts in OpenManage Integration for VMware vCenter User’s Guide available at Dell.com/
support/manuals.
Recovering OMIVV after unregistering earlier version of
OMIVV
If you have unregistered the OMIVV plug-in after taking backup of the database of the earlier version, perform the following steps before
proceeding with the migration:
NOTE: Unregistering the plug-in removes all the customization that was implemented on the registered alarms by the
plug-in. The following steps do not restore the customization. However, it re-registers the alarms in their default state.
1. Perform step 3 through step 5 in Migrating from 3.x to 4.0.
2. Register the plug-in to the same vCenter that you had registered in the earlier plug-in.
3. To complete the migration, perform step 6 through step 8 in Migrating from 3.x to 4.0.
Introduction 17