Users Guide

NOTE: For M1000e version 4.3 and earlier, the active errors are not displayed.
Viewing hardware inventory information for
chassis
You can view information about the hardware inventory within the selected chassis. To view the information in this page, ensure that you
run an inventory job and export a CSV file with the component information.
1. In the Home page, click vCenter.
2. In the left pane, under OpenManage Integration, click Dell Chassis.
3. In the left pane, select the corresponding chassis IP.
4. Click the Monitor tab.
To view the relevant component information, navigate through OMIVV:
Table 29. Hardware inventory information
Hardware
inventory:
Component
Navigation through OMIVV Information
Fans Use either of the following methods:
• In the Overview tab, click Fans.
• In Monitor tab, expand the left
pane, click Hardware Inventory,
and then click Fans.
Information about fans:
• Name
• Present
• Power State
• Reading
• Warning Threshold
• Critical Threshold
○ Minimum
○ Maximum
Power supplies Use either of the following methods:
• In the Overview tab, click Power
Supplies.
• In the Monitor tab, expand the
left pane, click Hardware
Inventory, and then click Power
Supplies.
Information about power supplies:
• Name
• Capacity
• Present
• Power state
Temperature
sensors
Use either of the following methods:
• In the Overview tab, click
Temperature Sensors.
• In the Monitor tab, expand the
left pane, click Hardware
Inventory, and then click
Temperature Sensors.
Information about temperature sensors:
• Location
• Reading
• Warning threshold
○ Maximum
○ Minimum
• Critical threshold
○ Maximum
○ Minimum
NOTE: For PowerEdge M1000e chassis, information about
the temperature sensors is displayed only for chassis. For
other chassis, information about the temperature sensors is
displayed for chassis and associated modular servers.
I/O modules Use either of the following methods: Information about I/O modules:
• Slot/Location
84 Chassis management