Users Guide

Table 14. Dell server Management portlet
Information Description
Service Tag Displays the service tag for your Dell PowerEdge server. Use this
ID when you call for support.
Model Name Displays the server’s model name.
Fault Resilient Memory Displays the status of a BIOS attribute. The BIOS attribute is
enabled in the BIOS during initial setup of the server and displays
the memory operational mode of the server. Restart your system
when you change the memory operational mode value. This is
applicable for 12th generation of PowerEdge servers and later
that support Fault Resilient Memory (FRM) option, running ESXi
5.5 or later version. The four different values of BIOS attribute
are:
• Enabled and Protected: This value indicates that the system
is supported and the operating system version is ESXi 5.5 or
later and the memory operational mode in BIOS is set to
FRM.
• Enabled and Not Protected: This value indicates that it
supports the system with operating system version lesser
than ESXi 5.5.
• Disabled: This value indicates that it supports valid systems
with any operating system version and the memory
operational mode in BIOS is not set to FRM.
• Blank: If memory operational mode in BIOS is not supported,
the FRM attribute is not displayed.
Identification Displays the following:
• Host name—Displays name of the Dell host
• Power State—Displays if power is ON or OFF
• iDRAC IP—Displays the iDRAC IP address
• Management IP—Displays the management IP address
• Connection Profile—Displays the connection profile name for
this host
• Model—Displays the Dell server model
• Service Tag—Displays the Service tag for the server
• Asset Tag—Displays the Asset tag
• Warranty Days Left—Displays the days left for the warranty
• Last Inventory Scan—Displays the date and time of the last
inventory scan
Hypervisor & Firmware Displays the following:
• Hypervisor—Displays the Hypervisor version
• BIOS Version—Displays the BIOS version
• Remote Access Card Version—Displays the remote access
card version
Management Consoles The management consoles are used to launch external system
management consoles, such as:
• Launching the Remote Access Console (iDRAC)—launches
the Integrated Dell Remote Access Controller (iDRAC) web
user interface.
• Launching OMSA console—launches the OMSA console to
access the OpenManage Server Administrator user interface.
Host Actions To blink at various time intervals, set up the physical server to
blink at various time intervals. See Blink indicator light.
Inventory and warranty management 53