Setup Guide

NOTE: The credentials can be a local or the Active Directory credentials. Before using the Active Directory
credentials with a Chassis Profile, the Active Directory user’s account must exist in Active Directory and the Chassis
Management Controller must be configured for Active Directory based authentication.
6. Click Next.
The Select Chassis page is displayed which shows all the available chassis.
NOTE: Chassis are discovered and available to be associated with the chassis profile only after the successful
inventory run of any modular host present under that chassis.
7. To select either an individual chassis or multiple chassis, select the corresponding check boxes next to the IP/Host Name column.
If the selected chassis is already a part of another profile, then a warning message is displayed, stating that the selected chassis is
associated with a profile.
For example, you have a profile Test associated with Chassis A. If you create another profile Test 1 and try to associate Chassis A to
Test 1, a warning message is displayed.
8. Click OK.
The Associated Chassis page is displayed.
9. To test the chassis connectivity, select the chassis and click the Test Connection icon, which verifies the credentials, and the result
is displayed in the Test Result column as Pass or Fail.
10. To complete the profile, click Finish.
26 Appliance configuration for VMware vCenter